Fine
Fine
Conical plug socket including assembly set (nut and disk). Fit for accessories with a diameter of Ø4 mm.
Fine
Same as above, only this plug socket is esspecialy made for the MONO glasses holder.
Fine
Conical plug socket for bonding into wood. Minimum wall thickness is 16 mm. Fit for accessories with a diameter of Ø4 mm.
Fine
Conical plug socket to be mounted on wall. Includes plastic plug. Fit for accessories with a diameter of Ø4 mm.
Fine
- Accurately drill a Ø8 mm hole and place the plug socket.
- To tighten the nut, use a wrench no 13.
- To align the plug socket vertically, use a hexagon wrench no 4.
- Load capacity: only for lightweight products such as accessories and glasses.
Fine
- Accurately drill (or have drilled) a Ø10 mm hole.
- Place the first glass ring over the plug socket, insert in hole and place second ring.
- Tighten the nut. Glass thickness may vary between 6 and 15 mm.
- To align the plug socket vertically, use a hexagon wrench no 4.
- Load capacity: only for lightweight products such as accessories and glasses.
Fine
- Accurately drill a Ø8 mm hole.
- Clean out the hole by blowing and degrease plug socket.
- Aply glue, Araldite® 2012, to the glue grooves of the plug socket.
- Insert the plug socket with rotating motion into the wood.
- To align the plug socket vertically, use a hexagon wrench no 4.
- Load capacity: only for lightweight products such as accessories and glasses.



























